|
Post by MXC-087 on Jun 18, 2005 15:19:08 GMT -5
I just got two new Stikfas, the Gen2 Alpha Male Ninja (black) and the Beta Female Jungle Explorer with Jungle Cat (redo, tan, green and yellow). I notice some accessories in both sets - the nunchuk looking handles with claw thing and the grappling hook for the explorer - have holes on the ends of the handles which seem clearly intended for a string of some kind. What sort of string do you recommend adding to these accessories, and how best to fasten them in place: merely tying them on, or using glue or heat?
|
|
Soma Cruz's no1 fan
Quick Slinger
I am... The 7/-/|234o|-|<!113|2!!! (Thread-killer, for you laymurz)
Posts: 130
|
Post by Soma Cruz's no1 fan on Jun 18, 2005 22:30:20 GMT -5
actually, i have the same question, i was personally thinking about using that clear plastic wire/fishing line stuff, and heat-molding the tip so it stays in...
anyone else have any ideas?
|
|
DeeJay
Quick Slinger
j00. got. served.
Posts: 183
|
Post by DeeJay on Jun 19, 2005 17:36:06 GMT -5
I'll post pics when I calm down. Grr...
I used an old necklace chain my mom was done with, and a paperclip. Snipped small pieces off the clip and bent them into rings. For the chuks, I used a length of chain equal to the handle width; it seems a bit long. Note to the wise - bend the paperclip into a ring (or use the drill press and a VERY SLOW SPEED to make multiple rings) BEFORE cutting it.
I plan to make a weapon from the chuk handle and the scythe handle with a 12-inch chain length for use with my 1/100 scale Gundam models.
|
|